Sam Fleisher
Member

I think I need to find some kind of therapy after being violated in ace hardware yesterday. The bolts are 10 mm I figured out. And like an idiot...

Is there going to be a garage sale in your future?

Temporarily out of stock Expected in stock Sep 08, 2023 - More Info New date! They went the wrong direction....

I too am a pack rat. I have too much stuff ratted away and don't know where I would look for them.

What size bolts for the threaded ones do you remember? Do you think the bar/ 2x4 running behind the lathe would work for a mounting place? My...

The holes look suspiciously like the ones on the nova 16x44 lathe...... Can't find anything on that website either.

I'm not sure if my sarcasm meter is twitching or not.... But I did check all of that and like I said after I moved it back into it's original...

Well, I don't know if you can apply logic to this but on the parts diagram the set screw for the motor pulley uses a 3mm wrench. So does the center....

The base sticks good? You haven't went down the rabbit hole of their track system? Although with that track system should a person be worried...

1) I've never moved the headstock since I installed other than when I did try moving it earlier. no difference. 2) ^^ 3) ^ It was still tight...

One thing fixed! Not the vibration though:( I was able to install my Axminster 114 chuck after I dressed the spindle with a file then re-polished...

Bearings felt fine, set screws didn't seem to be loose with the little short allen wrenches I used. Better ones coming tomorrow and I ordered a...

Just got off the phone with grizzly tech support and he said the same thing you did. Check all set screws etc. Take the belt loose and see how the...

I didn't even know to check those. Probably aren't easy to get to are they? At the most there might be a little wear on the edges of the belt. I...

Wow, from the looks of this Axminster SK114 I must have been seriously overloading that grizzly chuck! I hope the G0766 can spin this thing.

I ended up ordering the Axminster SK114 chuck package. It was on sale right now and I went with this mainly because of stainless steel and it was...

I just used 6 of the #12 stainless sheet metal with the slot and they worked fine. Put them into and out of green cherry and they didn't break off...

I tried a couple different things. When I took a direct link it wouldn't go because it was over 1000 characters long. It was a mess. I can get...

I was referring to Brice about the picture in the grizzly catalog differs from what my chuck that I bought years ago looks like.

I wonder if there has been a design change on the grizzly chucks or maybe a generic picture. My chuck has a bigger shoulder sticking out the back...

I ended up buying some stainless #12 sheet metal, a set with phillips and then a set of hex with a slot. I would have preferred the ones without the...

Do I need to put them on a host site?

I think the vicmarc 150 has a feature that I would not like. The quick operation bit. That would only be useful if you had an easy way to lock the...

The other day I had the largest piece I had ever put on the lathe so far and it really wasn't very big but it was off balance so when I would stop...