I have the 10" 7480... it still has the dip in it near the throat plate (top is aluminum).
Not a problem when using a Crosscut sled. Problem is when...
Good info to have (not that I have any tattoos).
A few years ago I asked the tech what would happen if I had permanent eyeliner and needed an MRI on...
I would take it apart and replace the bearings unless I was positive they weren’t done recently.
Cleaning up the dt ways might be just what’s needed...
There’s another wood movement condition to consider. Where the piece is sitting is there direct sunlight on on side during the day is it by a window....
Roger that sounds like a good teacher. My first carving teacher John was very much the same. He used stones and a strop. Someday I’m going to try the...
I would like to share a simple Christmas mouse carving that can be done with only a knife. I’m also adding a pic of the pattern that I use to cut out...