Edwin Santos
Contributor

Common installation practice may vary from region to region. Here in the Southwest, I usually see the top trim for pocket doors caulked and nailed,...

Very interesting jig. If I understand what's happening, the suction is sufficient to hold down the thin workpiece, enough to keep it from rising...

Hi, One design "law" that I try to live by is to not design drawers that are wider than they are deep, unless I plan on using ball bearing drawer...

Andrew, I use the Jessem Doweling Jig for any dowel joinery that is occurring reasonably close to an edge. If the joint is out in no man's land or...

The Zinsser product is a box with two bottles, each 8oz. Part A and Part B. You wipe on Part A, let it soak in for 5-10 minutes. I labeled and...

Many thanks for the comments! I'll report back in a few weeks with the desk I am obligated to make for my other (pre-teen) daughter. I'm going to...

I might have tried clamping the hardwood strips into sandwiches and while clamped, drill and glue dowels in the stacks. Alternatively you could use...

I was thinking the same thing Ron, but of course when I set it in her room, her first comment was that it would make a perfect make-up table. Look at...