• Tim Boettcher's Avatar
    09-10-2019, 11:46 PM
    I still haven't pulled the trigger on a dust collector, and at the suggestion of Clearvue, I contacted a Nordfab rep about getting a duct design....
    4 replies | 286 view(s)
  • Tim Boettcher's Avatar
    08-20-2019, 11:30 AM
    My shop currently only has two 30Amp 220v receptacles (single circuit) in the center of a 40x40 area, and a couple by the panel, and one in the...
    11 replies | 1037 view(s)
  • Tim Boettcher's Avatar
    08-20-2019, 11:19 AM
    Tim Boettcher replied to a thread Ducting for DC in WorkShops
    I'll give it another look, and get Norfab to get me a design and quote. When I looked at it last the seemed just about any component was in the...
    14 replies | 805 view(s)
  • Tim Boettcher's Avatar
    08-20-2019, 3:40 AM
    Tim Boettcher replied to a thread Ducting for DC in WorkShops
    Thanks guys for all the input...
    14 replies | 805 view(s)
  • Tim Boettcher's Avatar
    08-19-2019, 4:02 AM
    Tim Boettcher replied to a thread Ducting for DC in WorkShops
    Max main trunk run would be the 50' diagonal.. I don't envision much else other than a planer.. and I know they are the worst. I don't do that...
    14 replies | 805 view(s)
  • Tim Boettcher's Avatar
    08-19-2019, 2:11 AM
    The area is 40' x 40' with sloping ceiling ranging from 18' to 10'. I was just doing using the calculation based on the air volume - hoping I...
    6 replies | 466 view(s)
  • Tim Boettcher's Avatar
    08-17-2019, 3:41 AM
    Tim Boettcher started a thread Ducting for DC in WorkShops
    Seems lots of good discussion about Dust Collection, so I'll ask too. Looking at the Clear Vue Pentz EF5 with an 8" intake. The Idea would be to...
    14 replies | 805 view(s)
No More Results
About Tim Boettcher

Basic Information

Statistics


Total Posts
Total Posts
11
Posts Per Day
0.01
General Information
Last Activity
09-10-2019 11:46 PM
Join Date
12-27-2016