Tab Content
  • Rush Paul's Avatar
    07-19-2018, 4:36 PM
    Rush Paul replied to a thread Clear Vue Questions in WorkShops
    Aaron, if can attach the tool with a 4" port, you can run it off the CV1800 PROVIDED you keep the equivalent of that main 6" duct open at all times....
    11 replies | 366 view(s)
  • Rush Paul's Avatar
    07-19-2018, 10:17 AM
    Rush Paul replied to a thread Clear Vue Questions in WorkShops
    Aaron, have you downloaded the design drawing for the CV1800? It has all of the dimensions so you can check requirements. The standard wall mounting...
    11 replies | 366 view(s)
  • Rush Paul's Avatar
    07-18-2018, 2:13 PM
    Rush Paul replied to a thread Clear Vue Questions in WorkShops
    I follow a similar pattern to on-off cycling as Steve describes. The original owner of Clear Vue, Ed Morgano, posts in the Clear Vue forum the...
    11 replies | 366 view(s)
  • Rush Paul's Avatar
    07-18-2018, 12:25 PM
    Rush Paul replied to a thread Clear Vue Questions in WorkShops
    Hi Aaron, I use a Clear Vue CV1800 in my shop and I'll try to answer some of your questions in the order you mention them based on my experience:...
    11 replies | 366 view(s)
  • Rush Paul's Avatar
    06-28-2018, 2:31 PM
    I have a DeWalt 7790 (solid top cast iron arm, 3.5HP) with a 10" blade and a DeWalt Model 925. I use them for everything: cross cuts, bevel cuts,...
    107 replies | 6174 view(s)
No More Results
About Rush Paul

Basic Information

Statistics


Total Posts
Total Posts
34
Posts Per Day
0.06
General Information
Last Activity
Yesterday 10:51 PM
Join Date
12-24-2016