Bill Dufour
Contributor

I have always thought. a "Servo' brand power feeder would be the logical starting point for such a conversion. Often used as a power table feeder on...

Note to building owners. Do not ignore complaints about mushrooms growing on the wooden balcony. Bill D...

Of course the heaters will have to be replaced but it should pull in and close the contacts. It may be cheaper to buy a correctly sized used...

Will Grizzly sell just the impeller? Bill D

The coil look correct. I think the jumpers are stamped sheet metal. I do not see the power inputs. It should go to one or two and the other to...

Fluoropolymers, is the generic name for Teflon. Hydroflouric aicd is one of the worst things to get on your skin as it causes nerve damage so you do...

With hydrangas the flower color is set when the bloom starts. It will not change after it shows it's true color. the soil Ph can change the color...

I made my gates so the shutter can slide all the way through, self clearing. A air compressor helps. I find more and more uses for my gun cleaning...

South Bend? OP says the maker is out of the business. Bill D.

Why is the fire blocking so high between the studs? Bill D

Garage parking is easy to limit going to far. I lived in a house with a washer/dryer in the garage. The end of the garage was raised 6" for about...

Why replace yearly? Is this for aircraft or healthcare use? Bill D

I would get the cheap old ones and reform them before use. Seems cheap enough to try. Bill D ...

I have certainly read that the shrouded fan impeller works better but it can get clogged easily. I would think a cyclone would solve that problem. ...

John I have seen recommendations to slope the lines the other way so it all drains back to the compressor to one central drain. At any rate they all...

I think it is interesting to see that premium is still exactly 20 cents a gallon more then regular. With gas double or triple in in price you would...

A quality tank can have the drain valve off the bottom but with a internal dip tube to the tank bottom. Few have the dip tube. Best practice is to...

Just make sure the voltage is as high or higher. Easy enough if the terminals are the same type and sex or do they solder on? Bill D

I wonder how it would work on locks like for a car. They recommend no lube at all, or dry graphite. Years ago I read about. a British army study of...

It is designed to be a chain lube so it should work fine. I think waxing the chain is a hold over of mis translating British English. In the...

AFAIK It has teflon not silicone so no finishing problems. I did not notice any smell. Drys fast when it is 95 in the shop. Bill D

https://www.etrailer.com/faq-Adding-Electric-Over-Hydraulic-Disc-Brakes.aspx https://www.easternmarine.com/electric-hydraulic-brake-actuators

Since the new ring will not be a perfect match make it a contrasting wood or even brass. Walnut and ebony come to mind. Some would make the edge a...

I understand that 1/1000 of an inch is the minimum the human eye can see as no being the same. So you are plenty close enough. I have read 0.003 is...

Outlets mounted horizontally have to be with the ground to the left. This means Neutral is in top. Same safety reason as ground should be on top of...