Chris Padilla
Moderator

Nice looking project. Some questions: How tall is this bench? What is the slot for? Are the legs of the bench threaded for the vise screw?

Be careful using a tooth as your reference point as some manufacturers hollow grind the sides of the teeth, which can add error to your measurements....

I put the lathe back together today, taking plenty of time to clean it up, do any surface rust removal from when I had "rust-ma-geddon" in the...

You really have to look at the grain direction to decide what parts get routed with the template up vs which get routed with the template down. It's...

Edward, that cart is kinda like a portable version of the clamp storage that Jason of BurbounMoth on the 'Tube constructed in his shop.

Broke things like that on an older machine can present significant angst, especially involving castings. I'll also suggest passing on this one.

I'll raise you a complication, Chris... :). My Tersa head is three knife. :D Seriously, one of the beautiful things about the Tersa system is to be...

Doesn't flow well through the Internet for some reason...I guess it's too viscous.... :) :D

Yes, that's what I was referring to, Robert.

I have a standalone 24'x30' workshop and several thousands of dollars worth of woodworking equipment because of Norm and NYW. I recorded his...

Yes, you need to flip to avoid coming at the grain from the wrong direction and having it tear out at the least and do what happened at the most....

That was a really nice way to repurpose that bed frame! It's good metal and reuse is a lot better than getting rid, IMHO. If you process the...

That's a wonderful keepsake, Jason!

Robert, I don't see a strain relief on the cord where it meets the box on the ceiling...you may want to consider that, especially if you're going to...

Chris, you can do combinations of shorter knives with Tersa, but you'll want them all to be installed in different orders so none of the places they...

Keeping the thread going.

Exactly the same problem you encountered on the outside of the curve occurs on inside curves. You have to be aware of the grain ends and if the...

I've seen (and used them) a number of times. That was generally in newer, independent restaurants that didn't have a big investment in traditional...

Bandsaws tend to have a "range" for band length where the typical band length is what it is. So if your saw take, for example, a 105" blade off the...

Given how warm it was today (sorta...), I decided to move the sheet goods from the shed into the shop after moving some things not needed in the shop...

I bought in 2020 in the height of the pandemic. I thought I might have a haggling edge with cash. The dealer couldn’t have cared less.