Edward Weber
Contributor

So what you're saying is, all you need is a small brain to be a woodworker :D Come to think of it, I have seen evidence of this from time to time...

Regarding the wood, wood decays from exposure to oxygen. As an example, there is ancient Kauri. This wood is salvaged from bogs/swamps and is on...

Just some food for thought https://flooring-experts.com/hardwood-floor-thickness/

One issue is also finishing, I think everyone can figure out why

This well was the oldest, the new discovery blows it away by millennia...

I read that yesterday, very cool. Also just shows how much we don't know

+1 Typically, 1/4" inch is about the max where you don't need to worry, anything over 1/4" is when I have to consider movement. That being said, I...

I have a slightly different GO513, mine has the cast iron wheels and trunions. You need to talk him down a lot IMO, the anniversary models are...

If not, temporarily glue some stops to the outside to give the clamp something to register on.

What you're describing is a large donut chuck and it will work just fine.

If you don't mind me saying, this is very well stated and needs to be repeated often. At least once in every inevitable sharpening thread.

This is quite common IME as well, I have one

As long as your wi-fi signal is strong, when it goes out, you're sunk.

All it says is: "Hello! Thank you so much for the question. The SD208S was updated to be compatible with sawstop. Otherwise, they are essentially...

This is what Freud says of their Pro Dado set (no safety shoulders) https://www.freudtools.com/products/SD208S "Optimized blade design for...

Thats what I though, I wanted to be sure thanks

It sounds like you're looking for a model makers tablesaw Many of the modeling forums have threads on these tools

Many places in the country also have time of day rates. No one is charging their cars during this time then, so everyone is charging at the same...

Nibs? Please explain I did post a link earlier that Freud has a Dado set that they recommend for SS

Very interesting aarticle, thanks And if this kind of thing interests you, here is an article about Freud Carbide (and why I'm a Freud guy)...

Oshlun Dado chippers are round

Fleets are great test beds for all kinds of tech, from engines to suspension. tires and on and on. Out here in CA, just about every fleet in...

20 degree paring chisel + spruce = cuts like butter Now you're thinking of all the things you want to cut aren't you.

Big, easy to understand numbers If an HVAC vent blows on a piece and dries the wood a few percent, say 5, then it only recuperates 4 percent...

Yes, you're correct. I know my panel is full but not everything is used at once. On the other hand, everything electronic is typically drawing a...

Short answer is yes, standard 200a service is not nearly enough for todays electrified world JMO

IF, the table is in the direct flow path of a forced air HVAC system, this could have an effect on the top. Once again, IF the table is in this...

Need more information than what they're made of and finish. Do you use an apron or some other type of stabilizing support underneath or are they...

I'm a Freud guy, If you still use a Sawstop, https://www.freudtools.com/products/SD208S If not, https://www.freudtools.com/products/SD508

Squond This is mostly used when turning and easing off corners of a square blank until it's neither square or round. Bruising This is a turning...