Edward Weber
Contributor

CBN wheels come is all shapes sizes and colors these days. That "looks" like maybe it's a woodriver (woodcraft) brand...

In a "typical" stretcher to leg situation: The majority of the force is applied to the edge cheeks in the way of "racking". Leaving that direction...

Adding to everyone else, Years ago when working on cars, Subaru's were among the most expensive for parts. An alternator for that car is $350 I...

A lot has to do with where you live. Here in CA, a couple of large insurance companies say that they will no longer offer home insurance. They claim...

I would suggest some type of concrete epoxy. As Bill said, clean the crack thoroughly and follow the instructions.

Once again, I'm agreeing with you Jim. All this talk of, all you have to do is take it to a stone or break all the sharp corners, is all well and...

That sounds exactly how I make mine. Good and snug, which usually requires a mallet for final seating. I like to treat all joints pretty much the...

Speaking only for myself, To avoid what you mention, I chamfer the four corners of the tenon very slightly. This allows for glue and/or air to have...

A slightly different view In my work, joinery should be a tight, well fitted union of the wood components. In most cases, adhesive is there as a...

I use the Freud Thin Kerf Sliding Compound Miter Saw Blade on my RAS and SCMS https://www.freudtools.com/products/LU91M010 They are less aggressive...

I thought that the AI was going to replace us lowly humans. Now it seems that us carbon based life forms need to fact check the work of the AI. ...

Different fuels use different levels and formulations of detergents. These can cause deposits that clog injectors. If a "reputable" garage, like a...

Yep, that's all you need to do

If you buy good fuel and the car runs fine, as you say, you can probably wait until 60k or so. If you put in cheap fuel and your car doesn't run...

I heard that it was citing cases that didn't exist. Maybe it looked through the 20+ years of Law & Order TV show and found some, who knows. Not...

I find these results to be underwhelming. All I can glean is that the AI searched the web, instead of me doing it. The difference is, I can discern...

You could always use velcro or magnets Just a suggestion

That was 10 years ago, nothing has been decided. Call things what you want, just don't expect anyone else to call them the same as you.

https://www.ibctools.ca/about/

I think the point is getting lost a bit. It's not that .005" matters or not, or if it's close enough for most people, or don't worry about it,...

IMO, I think you need to pump the brakes and rethink what you're after. You want to bore some a 2+" deep hole into some sheet goods, far from the...

How precision a hole? What size hole? How far into the center, 24"? Could you use a plunge router?

Well there you go, a typical situation of who's right or who's not. In my shop there are vessels, jars, boxes and containers. They are what I say...

We always drill the re-bar for aprons, walks, patios, and landings into the building. The assumption is that there is going to be settling around...

Forgive me if this seems harsh but why are you looking at these tools for woodworking? There are tools better suited for the task. There are plenty...

Thats the way I was trained to do a landing like that. If there is concern about settling, we use poured piers rather than driving rods. How to get...

Eric, I somewhat agree with your point but at the end of the day, as they say, it's his business and he should know what's going on. The customer...

I have had a similar experience buying turning tools, 3 different times from two different sellers. This was over a 1-2 year period of time about 8...