Edward Weber
Contributor

Well I think you inspired me enough to go make a few more trays/boxes, thanks for posting

+1 My immediate thought was, "so you like rocks do ya?" I hope they give them the maximum penalty for this. Sadly it seems, this has become some...

Sorry to hear, thanks for posting

If the trunions are cast iron, not aluminium, I wouldn't concern myself too much with the weight. You can only put so much on the table at one time,...

Congrats, please let us know how you like it

I made a rough & ready mallet for whacking my froe and pegs and whatever else sits still long enough. This is Mulberry from some cut-offs on hand

I think you could use some "different" type of storage :D If it works for you it's all good. I have to agree with the sentiment of them showing up...

He who dies, probably forgot to return the tools he borrowed. That's a joke

I have a 17" Grizzly https://www.grizzly.com/products/grizzly-17-2-hp-bandsaw-w-cast-iron-trunnion/g0513x2 which looks to be very similar and I...

I've learned a lot of technique from this guy https://www.youtube.com/@kengodfrey1956/videos

I was torn, I voted no but there are a select few I would lend to if they lived near me. Oddly enough, this is the same group of people I would give...

https://ceramics.org/ceramic-tech-today/ceramic-video/video-transparent-aluminum-from-star-trek-to-reality/ We're almost there

Guys like this usually have names like "Lucky" or "Lefty"

The tips are made to be interchangeable, gat a new tip, there are many profiles to choose from. Many of the tips for these tools are sharpened at 80...

Correct me if I'm wrong but this is a rather simple system. It's a self contained cattiage that you can clamp any saw plate to, so why wouldn't a 10...

This is how all of my sub bases are. There is a small amount of play in the mounting screws. WHen using a centering cone, everything lines up to the...

When I say things like "the tablesaw isn't dangerous, it's the operator" This is what I mean

Well said, How big will your box be when all done or should I say, how many chisels will it hold?

No regulations or mandate is gonna stop stupid. The is just no point in doing this at all.

I bought a set of them, mainly because they were about $9.99. I've not gotten them ready for use yet but they should be a good enough set for...

You can wait until it starts to squeal, if that's your preference. At 90k you're going to need the rotors resurfaced anyway for the new pads. Please...

It may end up being a magnet on one door and a plain plate or washer on the other. I think a forstener bit is the easiest way to go. Drill one door...

If you're a woodworker, you make jigs, that's just the way it is. IMO Like you, I'll make a jig for a project, paying that much for a simple jig...

It depends on the weight/geometry of your vehicle, your brake bias and how/where you drive. Not to mention what type of brake pads. There is no...

Two schools of thought here. 1. Sell to the people you can, ONE good, quality product every 20 years or so. 2. Sell to as many people as you can, a...

How is finish on the glue area any different than glue on the finish area? I understand what you're after but where does it end. The danger of...

Very informative thread, thanks. I don't know if it answered the OP's question or not but it answered many of mine.

Exactly what I was trying to say. I've seen newer tools quit supporting and offering parts after a very short time, rendering the machine useless....

I have a Laserpecker and it works fine for what you described. I have the LP1 pro, it's pretty basic but can be used anywhere. It's small and...