ChrisA Edwards
Contributor

I think it just has better clamps and a larger width capacity.

I bought the Woodpeckers Coping Sled when I first started this hobby a few years ago. Of the commercially available coping sleds, I wish I'd...

I have a 1 1/2HP Jet DC system, which is probably very similar to yours. I made it two stage with an Oneida XL Cyclone and a 55 gallon plastic...

I went from two similar machines to the Hammer A3-31. I had the DeWalt 735 and a Jet 6" jointer. There is no comparison in cutting power between...

I have a Hammer A3-31, so have looked at the mortise attachment before, but have never been really excited enough to pull the plug on this device. ...

Interesting read, I picked up a pair of tri-focal progressive safety glasses yesterday. It's my first time wearing any prescription glasses. At 62...

I bought the Inch gauge, about 4 months ago, for my A3-31 and likewise bought the Imperial setup for my Incra LS-TS positioner on my table saw. I...

Agree with the post above. I made my first router table out of two pieces of 3/4" ply with laminate on top. Flat as a pancake and never sagged or...

I swapped out my PCS175 to the 3HP motor a couple of weeks ago. Pretty straight forward swap. I took the left table extension off to give myself a...

Excellent, Are you taking orders for those brackets?

Tim, not sure how much you read the other threads here, but if you do, you'll see I've pretty active on a few threads about Shapers. I've been...

I'll admit the Hammer prices are high, but you are comparing a 12" Jet to a 16" Hammer, a little apples to ranges in size. My A3-31 (12") was...

There is a nice thread here about improving dust collection at the bandsaw. ...

Thank You, this will be my first Shaper. I would like to get the best I can afford and only do it once. I'm hoping to sell one of my Ducati's and...

Thanks, that makes perfect sense. Thank you for the explanation. I'm still searching for a used Shaper on eBay and Craigslist, but it's looking...

I did a google search but couldn't find any info on this Felder event, can you tell me where, when and how much this seminar is, thanks. Also,...

I have the short extension table attached to the out feed side of the planer. This seems to help as it provides a little more support. I also try and...

I'm with Jim on this. I would do it in two pieces. The top piece, the part that you see and transitions between the two floor heights, would be a...

I've not used the router table that much on the table saw as I have a standalone router table as well., but the few times I've used it, it's worked...

I have the Incra LS rails and fence on my SawStop PC 175 36". When I initially bought my SawStop, I had to roll it away every time after use, so I...