George Yetka
Contributor

Overarm sold Blade guard available

steel does get work hardened. Milwaukee has some new bandsaw blades i bought in a pinch this summer. the box said it was good for thick steel but...

the festool stuff while expensive is very good with adjustability. the only other routers i have are palm and one in a lift.

https://www.amazon.com/Black-Swan-Mfg-Co-04085/dp/B008KOIQEA/ref=sr_1_1?dchild=1&keywords=black+swan+no+hub&qid=1610396857&sr=8-1 but mentioned...

https://www.youtube.com/watch?v=ESSU7EmT-cE ...

Slowly open cleanout before taking the clamp off to make sure its not full. Rubber will get hard and brittle and shrink over time. I would...

I like them use them for all plywood and longer rip cuts. Only regret is I lost my shelf

Do not lift by the jointer bed they are pretty adamant about that.

Avoid culligan. Im a mechanical contractor so i got a deal on their gold equipment. Ive replaced alot of parts in 5 years. Go with fleck. Backwash...

https://jessem.com/collections/router-table-packages/products/ultimate-excel-ii-package I have this one without the casters. It is a nice table Added...

Woodpecker can also be had from other suppliers at the same price with free shipping. They're quality tools that are expensive but only relatively....

Anything big enough to make cutting board gets made into a cutting board Anything big enough to make into coaster gets made into coaster Anything...

you can remove that plastic piece too and bolt plywood using those 4 studs shown

I took that one apart and bolted a 5 gallon bucket to it with sorting trays to sort brass for reloading. It worked well for my purposes. There are 3...

I would say make a couple frames out of something else and put these in them.

I agree shipping can get expensive(boxes,packing material,shipping rate itself, plus labor to pack item) But I have stopped a purchase with them...

I have a piece I bought a few years ago. Sliced off a small piece to throw in a cutting board, and after letting glue dry took it out of clamps and...

Ive been meaning to upgrade to the floating. I rarely had the guard on the saw so it didnt work that well. I put it on for large plywood sessions....

the Midi has 10%less cfm. Not sure if thats critical for you, or anyone. I run my 26 like 75%power So the midi would work

If your getting rid of domestic dust(no walnut) I think alot of farms will take it. I alternate with trash can and dumping in the woods. Usually dump...

Time to print, quality of print, and size of print can be your only restrictions. I have a cheeper machine and have batched out alot. (mainly...

Dont know if its the beard but I couldnt get the rzr mask to work for me fogged eyepro pretty bad. worked well while sanding when i could take off...

I got the best woodworking gift of all, time in the garage away from kids to do so. On a day of my choosing. And my mother in law doubled down by...

How about some ratcheting knobs. Similar to this but in the apropriate thread...

Maybe a small rubber strap wrench could help you. I would just avoid overtightening with the added mechanical advantage

I have had the 3hp pcs for 5 years or so and love it. Dont get the 52" unless you need it. I may cut mine down. Im out of space.

https://www.youtube.com/watch?v=xJ_dhbIdGqE

1/2-1 Spax (dont love them kind of soft) GRK are always available at HD for anything bigger than 1"(and have performed very well for me and cost...