Adam Herman
Contributor

and not everything listed as QH compatible will fit.

I would do a bent lamination of VG DF or similar grained Ash with Kevlar or carbon fiber between the laminations, and wrapped around the outside at...

many implements have different distances between the 3 pins, a std. quick hitch also requires the use of a bit longer pto shaft. at least on my...

I run grab hooks and a chain with one grab and one slip. seems to afford me the most length and rigging options. I also have a hole from a PO in the...

good luck Jim! a feverish pace! My permit finally got unstacked from the bottom of someone's desk and was sent to the builder. now he is 2 weeks...

I'm planning to run Romex for the lights and EMT surface mount for the shop portion. set up a laser in the middle, and start going around the shop...

what tooth bar did you go with?

Nice! I'm still waiting on permits. :mad: hopefully yours go smoothly.

I have no experience on a river table, but rebar seems like a poor choice. its low quality steel and it will only hold the epoxy, not the wood and is...

a bit of ballast in the bottom may make them a lot more stable, looking at the shape and weight distribution.

and remember you can increase your cost basis by doing capital improvements to the property. this is one of the keys to owning rental property for...