David Weaver
Guest

Every time we get one of these ...I think of the old oft used TV plot where a plane pilot keels over at the wheel....er..”stick”, and a passenger...

Yep, the out feed table must go up a little more. Use tiny steps and you will get there. If you go too high,you will have to drop down and start...

John,thanks. I tried a “reducer “ ,long time ago, It would not dissolve the flakes. But I’m not saying that none of them will work. I do think...

Could have been caused by someone fighting it. Remember anti- windmill arms have come a long way since Don Quoxite. Or maybe the guys who...

I’d get another realtor. People sometimes act like dogs in checking out houses . A dog always thinks a used dog house “smells bad”. One of the...

Nice work. I’ve made lots of footage of what I think was just like that. But I was using machines. That pattern was called “Richmond Rail” and they...

Agree with Mark. My guess is they they were just wiped off on both sides after use with damp cloth, then hung from ceiling so that air would be same...

The wood often moves to straighter when you face the convex side. You have to be careful. Set jointer for just 1 /16th.

Yes, buy a SINGLE FLUTE router bit.

More kinds of alcohol would do....if the tops were on tight. Is that is in-store vandalism, or factory screw-up instead of screw-down?

Ole, Yes it’s sad they let go of it. But maybe LEGO wil pick it up...might be easier than getting kids to pick up LEGOS !

I think the vise is mainly for sharpening saws. Seen that type used for that several times in shops. Google up pics

Lot of of good relevant info here. "1/4 inch chisel". Narrow chisels chip easier because they are usually used just like all the other chisels. So...

I think the stuff with bitterent was for lab use . Denatured means poisonous. The law requires it to be poisonous, that’s the only way they way...

What I heard is that it has to be poisonous now ...Uncle Sam says bitter and nasty tasting ain’t enough. Guys who will drink Sterno juice...

Well, when you get the stuff, put the top on the bottle and the mixed shellac. Even if you just get a phone call. Many years ago I bought a...

the 95 % works well . But just leaving the top off for a an hour or two on a humid day will ruin it. The lower proof only desolves........

It will not work . Way too much water.

Thank you Jim. My point was the typical smallest units on most of my imperial rules I can see, if I squint. Not true for the smallest ones on my...

And there is a good reason for the veneer to not go over 1/8”....because it wouldn’t be a veneer anymore ,It would be a “facing”. So anytime...

Well, I’m lost. Didn’t say anything about poverty. It was about seeing . We have had posts saying 64ths are hard to see that were followed by “me...

Not joking , and some USA organizations send old eye glasses to be used in other countries . The need would be less with BIGGER MARKS on tape...

With ‘mercan tape measures you can choose between having 64ths or ....not. With metric the teeny millimeters are just a grey line to anyone who...

People say that but, of course, our names come from our countries and not our continent. For Canada, it Canadians. For the United States of...

Joe ,I remember one really large job where I actually changed the couple’s choice. All the doors were spect. 1 and 3/4 “ , I told them it was too...

Have to disagree on 1 and 3/4. It’s okay in some places ,I think it depends on the situation . Right now a lot of clunky ,everything must be...

Well, I see now that I misunderstood the problem. The bit might be contacting the bottom of the collet. It should be be 1/8th off the bottom.

Not at all ! No wood project has more appeal than beautifully done wooden treasure boxes ! Some of us are just too busy putting some more decals...

. Buy some Bitrex on eBay. It’s the worlds most bitter taste. It has no smell, so you need to mix in something that does. That will stop the...

Agree with John. There are a few exceptions, one place I worked had an old broken up piano that was made of old swetinia mahogany and veneered...