John, thanks for the reply. I have used a 2k exterior rated poly from Milesi on an exterior door with no real weather exposure and it was a dream to...
These saws are hard to find used. I have been looking casually for 2-3 years for a MM20 to replace my 80s era Italian 500mm saw. I’ve seen a handful...
I replaced all 8 caps and fired it up. It seems to be be operating fine now. There is also reduced “chatter” in the motor during start up. There used...
I have straightened a jointer fence by suspending it between two 4x4's and stepping on it slowly applying my weight. It worked like a charm. I think...
I would use PVA glue of your choice but instead of trying to clamp it off the plane, reinstall and use the stud that holds the tote in place to clamp...
It works properly now. I reset the 60 amp single phase breaker to the RPC (which I had already done once earlier before posting) I also went through...
Adam, thanks for the reply. I don’t know how to visually see which way the RPC motor is rotating either now or before as its integrated into the box...
Today I went to use my planer (3 phase, 9 HP) and when it wouldn’t feed the board, I realized that the motor (cutterhead and feed works) was running...
For anyone in commercial shops looking for blades check out Dimar or even better FS Tool. Both have solid true plates and massive carbide teeth that...
Matt I have played and worked on 4-5 Unis. The one I have in my shop has washers from the factory between the metal base/stand and the cast iron top....
I have a jet 20” planer that I put a helical head in a few years ago. I still get some tearout whenever the grain goes nutty like near a knot. Really...
Home Page
Find latest posts
View Articles
View Blog Entries