View Profile: Stephen Rosenthal - Sawmill Creek Woodworking Community

06-04-2023, 3:13 PM

Stephen Rosenthal replied to a thread Recommendations for a miter saw (which will be on a flip top stand with planer) in General Woodworking and Power Tools

I have a Makita LS1013F, which I believe is an earlier version of Marc’s LS1019L. Great saw. I’ve also got a Dewalt 735. Not mounted on a flip-top...

6 replies | 556 view(s)

06-04-2023, 11:13 AM

Stephen Rosenthal replied to a thread Searching for a decent knife edge marking gauge (Hamilton?) in Neanderthal Haven

I have a Hamilton panel gauge and 6” marking gauge (both walnut, not that it matters). Also a Tite-Mark wheel gauge. I haven’t noticed the issue you...

8 replies | 599 view(s)

06-01-2023, 11:54 PM

Stephen Rosenthal replied to a thread 60 or 80 tooth blade for a RAS? in General Woodworking and Power Tools

Don’t own a tablesaw. Instead I’ve got 3 RASs, setup for crosscut, rip and dado. The crosscut has a Forrest Woodworker I 10 x 60t as designed by Mr....

14 replies | 1212 view(s)

06-01-2023, 4:31 PM

Stephen Rosenthal replied to a thread WTB - Lie Nielsen 18° Skewed Jaw Pair, Right in SawMill Creek Classifieds

John, I purchased the Veritas Mk.II honing guide with most of the attachments (including skew register) before LN released their honing guide. It...

7 replies | 648 view(s)

06-01-2023, 1:55 PM

Stephen Rosenthal replied to a thread Delta Rockwell Model 37-290 Jointer: Completely Restored in SawMill Creek Classifieds

Phil, Those are stunningly beautiful restorations. Mucho respect! That said, and I’m not trying to pour cold water on potential sales, I’ve...

11 replies | 1546 view(s)