Warren Lake
Contributor

my past machines were solid roller but have one now that is sectional. Id look at what is used to spring the rollers. Some have springs and some...

Bob Vaughan past has a past you tube that is pretty complete and accurate approach.

two large bags of frozen ones in the freezer. I looked at the nursery and they had over 5 types of blueberries. Do you have one your prefer or...

set up time? Its part of the trade and it goes fast. Machine I have now I still have to set it up, I still have to change bits. I was making...

They work, chisel care most important. I use what i have till I buy a dedicated machine in that case a chain and chisel mortiser. At the time I used...

there are mortise attachments for drill presses

went from a cabinet saw to a small slider probably 30 years old. One day saw sawdust on the floor up to six feet from the saw. Forgot I had...

Never had one but if i join the club ill go for a Smart Phone. Maxwell. https://www.youtube.com/watch?v=3eik96tIjAg

or convert your truck. Converting classics seems to be advancing fast. My car builder friends hate I even look at this stuff. The first pick up is...

crashed a number of times last few weeks approx didnt pay attention to the time, even some stuff it would not play as it kept crashing. Been fine...

ah makes sense. Pretty amazing thing to do.

geez Tom are you a Gypsy?

Lots of circumstances probably four or five. Doesnt change the fact that there are so many people that have never been taught what can go on if you...

IF you are in a trade you learn it instead of buying a gizmo. You can buy a super car and there are enough crash and burn youtubes of the people who...

US made Newtons were very nice quality machines like some other US made stuff. They had several models this one with pneumatics. See them for sale...

years back came over a hill going east from alliston ontario headed to Cookstown and there was a group of lights in the sky on my left. I drove...

from years on cabinet saws nothing was clamped. The excalibur cross cuts had sandpaper on them and stuff didnt move. Now with a slider you can work...

id have no attraction to those machines. if for some reason I did id want an adjustable outfeed. Its not more work its less work, your knives...

feather boards and hand feed. Every human is a power feeder.

Brad had different suppliers past and not sure which one. Had some offcuts and remember counting layers a few years ago. Have some other thicknesses...

Thanks on that. All voltage measures were below 10. I saw 3 or 4 I saw 6 or 7 and it was like it was creeping up as I held the key in the final...

On the left measures .7285 -.7300. Its been out in the rain for some amount. Likely a spacer when lifting the car. One on the right from...

I dont know when and most likely different suppliers made it different. The outside layers were not as thick as the core layers on that. Ive bought...

I think there were several baltic states that made Baltic birch maybe four or five, Russia only one supplier of them. 3/4" was 15 plys and dropped...

if you have gone past the end I think some can drop down too low and not engage when you try and raise them. Do remember one putting a jack under it...

used the 2" senco to staple down all the 1 x 7" solid pine on my first roof rebuild. All the nails from original were loose, i hammered them deep...

both the old Europeans I knew best had combo machines and used them 40-50 years.

I just learned from my truck then questioned one of my hot rod friend. My battery in the 72 pick up measured 12.6 volts., The truck would not...

you did and not ignored. Just how many grounds and where and I had not got that far. From the bit ive learned so far it could have been a few...

your trick did work once or twice then not. So last night got back to it and put an amp meter on the starter motor, I video taped it and have to...