Warren Lake
Contributor

Switches are a part of machines. Gizmos are all those plastic and other things with wheels and. No use for most of them but a mag switch yes...

ripped tons of 10 foot solid, if a board started to close and some amount did I just lifted them off.

if power went out and a machine was running it would not start when the power came back on. The switches take care of that when the coil disengages...

The day went well though one niece got there before me and for as pristine as I left it some very large bird maybe a condor or some prehistoric beast...

no limit on the trees and why id rather have them than a fence. Parents 45 feet tall you didnt see the homes that bordered their property. They put...

agree didnt buy his, in the beginning it was only info then this is a sales thing. Doesnt matter its the info and i have a good coffee place. I did...

thanks Bill I know all the movies well. I think they have that trimmer at home depot but ill wait till its battery powered. I think I had that...

if you are rich the laws may not apply to you, look at Drakes home on Post Road. Those fences are probably double allowed. My view fence doesnt...

if you want straight material rip it over size then machine it again.

Jacks number is good 1 HP for every 4" of jointer. Look at any larger jointers and that is usually the case or more. The General 8" it came with...

Ive seen some you tubes past hooked up to welders and the ones I saw didnt work.

I barely look at grain, maybe edges maybe not. directions changes in many boards, put the board through and it will tell you. Feed rate is most...

feed rate is huge, being able to control it over and above many planers is the difference between blow out and clean cut. When I have time ill be...

taught hollow ground by cabinetmakers. One aspect right off the bat is there are two points to rest the bevel on when honing, makes it easy and...

if you judge an Excalibur then consider there were likely five generations. I had two on one saw, they were first generation and primitive but on...

went out after 4:00 am Sat (friday night) sky was full of pulsating patterns. No extreme colour and not super bright but tons of it. Video taped...

got done today. boiled water several kettles woth into a cooler. Different automotive details brushes and only one or two of 10 was strong enough....

few photos, two from the canadian site. Be nice if the you tube showed the saw working rather than just running. Makes sense if you are wanting to...

I don't get blow out as I climb cut but its hand held so you have control, your thing doesnt lend itself to that sure you are using a router table....

its being played through the same TV and the same Receiver,non of that changes Either the computer DVD and audio portion in it is equal to and...

I don't care about recording its only playback what I want to know is now I run a Sony DVD for the picture into a computer or direct to a TV ill...

Thanks Larry, here is how I run the lap top when I had it out, all fits into an old samsonite briefcase. I cant stand the mouse on a lap top so...

You can choke down on stuff I used to use vice grips on the hose to not full close, you have adjustments and can make a very fine spray like a tig...

Agree with Dennis I once didnt hire an arborist cause of a joke he told me. After I said your not the guy. Hired someone else and he was excellent. ...

im guilty of that. I usually dont proof read either so far from ideal. The old guy had poor english at times but good most of the time. I saw past...

get a pressure blaster and you can run it low if you use Aluminum Oxide 25 lbs to 50 lbs will do work. Ive done car parts in that pressure range. ...