Warren Lake
Contributor

think its early Art Vandelay.

Thanks thats getting pretty complicated. Id rather just lower feed rate if had an issue with chipping out. The woodmaster can cut a moulding in...

some of my shaper knives have a secondary bevel on the bevel side. On jointer and planer when I put a secondary bevel on its on the bevel side of...

whats the front of the blade? the bevel side? Past moulding company owner that had two told me they put a secondary bevel on at times and that it...

or just do what the old guys did and cut a slot both with your table saw and run a spline.

old guy had walnut trees he planted when he got his shop property. In his apprenticeship he said the old guy there went in the forest and picked...

Hi thanks past had seen it stated "some Kale" is biennial. Same time some of what is growing there this is second or third year. Some of it...

do some tests then polish. Car polish works fine.

have done lots of polishing but could not tell you what you use. When you polish a car any car you start with a pad and polish combo you know and do...

I went into settings and looked around then into problems and looked at different things. I could be in there for hours. No where did I see a way to...

thanks ill look late tonight I just started to type an email and it locked by the fifth word then a few more times on two sentences. Compare a few...

salice also makes a hinge that works for partial overlay. Think its a 170 degree one.

sleeves work fine never had one come loose. Ive used routers for very heavy work in the past, ive snapped bits pushing too hard.

have two lengths of ulmias, prefer the longer one its more stable. Even so its fastened to a stair case to make it more stable. I some how...

further on this issue ive gone to the library and used firefox to get to the web mail and typed some emails first one fine second one locked up...

dont get the issue all my routers take a 1/2" bit. If you use a smaller bit of any size you have a sleeve that slides in to take 1/4" or other sizes....

kale adventure still continues in the last days they have all grown flowers. right or wrong I cut them off as they were headed to be basketball...

Hi Tom from your posts you are unique family. I likely said that the oldest lady ive seen was Margaret dunning who gave an award to a friend...

I was once told that replacing phenolic ways on an old altendorf would be over 4k. had a german tool and die maker friend that would have figured...

Dave were you working with Lilliputians? The belt sander was my stroke sander till I built one. Then bought a real one, later replaced that with...

sounds like most of them work well. Ive had mine so hot a number of times I cooked hot dogs on it. I got a deal on a ton of them left over from saw...

I like vari speed on grinders and would not buy another without it. Never tried it on a belt sander I just move faster or use less pressure but...

3 x 21 Rockwell with lots of hard use on it only the switch replaced. IM used to that so id buy the same in Porter cable, not as good but would...

SCM stuff I have in that colour are from the 60's. Often you can date from the serial tag if you know how they did it

I cant visualize how that is possible other than if there were two cutter heads cutting 90 degrees to make the tennon like in a tennon machine. ...

so far not had issues with bugs. At least the question is answered about leaving the stems or having to start from seed again. Plants are growing...

Its cutting on the back stroke. there are also different results as albert said that is the best one. I never questioned why they taught us not to...

looks like a new machine so would hope it came square to the table. Put a dial magnetic base or other way on the spindle and do a rotation see what...

no issues with the mortising on the SCM combo as the mortise is on the back of the machine. Any machine will need support with long material. I...