Michael Short
Member

Jeff,

I did get them. Thanks very much. I have not had much time to work on it yet but planning to. Ray told me at the meeting the other night that you were going to send him a copy as well. He is wanting to make one of them.

Hey Mike, how have you been? did you get the wineo instructions ok?

Hey Mike
I'm looking for some plans for an end table, where do you get yours? I looked on plansnow and found a roll top desk I want to make but still looking for the other. I did find one I might want to do in a back issue of fine woodworking but still looking. Any suggestions?
Thanks, Bill

Hey Mike

Thanks again for lunch, next ones on me. Here is the link for that chair we talked about, let me know what you think.
http://www.sawmillcreek.org/showthre...=rocking+chair