Jim Dwight
Member

Tim, i also built a filler table like others suggest but I didn't always have it. I found making my outfeed table about 1/4 inch lower than my...

As long as the parts have enough "meat" for the domino I would use it for several reasons. First, a domino gives you much more long grain to long...

My track saw is a DeWalt although I use an Evolution saw some when I am volunteering at church. I have DeWalts long track, it's 106 inches, and I...

My experience with hickory is much more limited but consistent with what Lee said. I put down about 600 bd ft of pre-finished hickory flooring when...

If the nut that secures the fence is tight it will not move. It is one of those nuts where you have to lift the plastic piece off the actual nut...

Baltic Birch is probably your best bet. I haven't shopped for it since Covid but I assume it still can be had. It isn't totally void free but I've...

I've only made interior doors so far but may make one for my current house (which is about 55 years old) and have been thinking about making a new...

I made a little mini sled for my bandsaw just to cut my home made dominos to length. I have common lengths written on the sled. It is totally a...

It's probably not needed but I will add my .02 to agree with Jim Becker. The important part to get glue on when using dominos for alignment is the...

The issue with inside miters is not that they cannot be cut easier or cut to fit very well. The issue is that wood does not just move across the...