Mike Burke
Contributor

So, is there a best option ? fixed bed or fixed motor/cutter head ?

So I just realized something that I have never paid attention too. I haven't been around planers much , never had one, but just noticed. Fixed...

Thanks for the advice so far. I think I'll go check it out. I know what he is asking $ and I know what I would like to pay but.... If it all...

Doesn't look like its on there. Should have one . I looked at the manual and there should be one. Better check

I use google photos. saves all my photos so I don't have to keep them on my iphone. I can go to google photos, copy and past them to my desk top...

Thanks for all the replies and suggestions. I like the brass back traditional look. The straight blade would probably suit me better at this point....

Dave No kidding, Thanks for the offer. That would be most helpful also. I will get going on some drawings and get my list together. Thanks I was...

Thanks Joe Woodsmith Magazine Vol. 42 No 249 It was one of last years later months. I do have one little nagging problem. It doesn't always sit...

Rob, Very Nice !! Looks like it's 100 yrs old....and that's a good thing isn't it ? :) I would appreciate your drawings for a starting point. I...

Bill, thanks for the tips. Interesting technique for the spindles, kind of like a stair banister. I have been eyeballing your Stickley pieces you...

Thanks Phil I see that grain pattern on the photo of this table. Are some Original Stickley pieces mitered corner legs so the quarter sawn grain...