Grant Wilkinson
Contributor

In addition to Jim's advice, be sure to write to support@vectric.com. The do reply. I wrote to them about the space bar issue, FWIW.

I bought the upgrade from VCarvePro. Cost in Canadian dollars was just under $300. I bought now because Vectric warned that they will be increasing...

Very nicely done, John.

That's good advice, Mick. As of yesterday, they were up to patch 4 of v12. From what I understand, there will be more coming soon.

Tks, Jim. I put that into Amazon.ca and it sells for $321. So just about double. Adding in our federal taxes, it's just over $360. I'll stay with...

Late to the party again. Been there, done that too, Jim. Nice save. The cabinet looks really good. FWIW, when I have mis-drilled, I plug the holes...

I preferred lexan when I made mine. It does scratch a bit easier than acylic, but it's tougher. If you go for acrylic, be sure to get cast, not...

I have an inexpensive Simonize model, sold in Canada by Canadian Tire. It does a decent job of foaming and rinsing the car, but does not compare to...