Patrick Varley
Member

Might be missing something, but if you don't need anything fancy (doesn't flip, no micro adjust, etc), a piece of hardwood with two t-bolts in...

(OD of the bushing - Router bit diameter)/2 = the distance to the cutline (of the cutout/mortise). But then for a circle, you'd multiple that gap by...

Don't get me wrong, I like solid wood too. But glued up panels in bathrooms seems like a recipe for problems. And as Rob mentions, there are Euro...

Thanks everyone for the feedback. Rich: Good tip on the shellac. I have made some other stuff and been successful in matching to the woodwork in...

I bought a Chinesium knock-off for about ~$40. Was a bit off on arrival, but it had the screws in the cross piece to allow adjustment. No complaints...

https://youtu.be/GN4yr7vp4I4 I'd recommend watching some additional videos on sharpening. There are a million. But one key is understanding the...

My preference is #4/2H, specifically Ticonderoga, for general shop use. Fainter lines, but it's a hard lead that doesn't require as frequent...

You can buy it off Amazon. https://a.co/d/57SVTPS Amazon doesn't have the metric, but Walmart does. ...

Perhaps I'm missing something obvious, but why not just buy black oxide coated stainless screws? ...