Tom Trees
Member

No bother John Two other tips which may well be relevant for someone in bother. Fettling the underside of the cap iron. if one cannot remove a...

" Yes the cap iron is less than 1 mm from the blade..." So you understand that this is a two plane process. You have honed your cap iron at least...

Heard Schwarz mention he was going to visit on a padcast/interwiew, haven't seen anything more yet though. Here's a nice little video on the subject...

I'm curious whether Greg tried adjusting wheel depth and it gave undesirable results, or if it made little to no difference in the blades position...

As for the table being flush at the slot, There's adjustment nuts in-between table and trunnion for both leaves to be flush, and also for making...

I don't think the SNAC line were ever able to tilt 45, Maybe with the Laguna, as their spec table differs, well on the SNA line anyway. The...

I've been trying to work out where the top wheel should be on my machine... seems to make little difference to me as of yet.... After doing some...

Can't be beaten! I actually bought a new StanleyTM tool as I kept using up the organic variety, it's good enough to do the job for me. Hopefully...

My guess why this isn't working for someone who's watched those guys is the mouth is set tight, and thus giving the impression the cap is as close...

Guessing your making money comment was referring to Cosman? I was strictly referring to the technique of a flat bench, cost's nothing. Although you...

If you'd like your questions explained in video format, the two David's will set you right. Mr Charlesworth for teaching the proper use of the...