Jeff Ramsey
Contributor

Likely a periodic special price. $1K off would put it at a very attractive price point. If you're planning on needing the accessories, such as the...

One of the things I love about this time of year...

Butternut looks like walnut, but is lighter in color (and slightly softer) which is why it's often referred to as "white walnut". I don't see that in...

Not maple including ambrosia bug decorated versions. I'd say a "nut wood" of some sort, like pecan, hickory, etc., especially if it's hard and heavy.

Think...polyurethane glue. (Gorilla, etc) :) No reason a finish couldn't be formulated that way, too, I guess!

Those woven doors are stunning!

I just started doing our windows as part of preparing for listing...I'm thankful for most of them being able to be cleaned both sides from inside....

In general, I'll guess this is possible. It would be helpful to see the actual headboard to put some perspective to it!

Sometimes ya got to punt...this may be one of those times.

Dennis, your son did a great job on that project! I hope he continues with the craft, too. This past week had no "woodworking"...just a lot of...

For a small shop that wants to get some level of automation to dust collection, automated gates can fill that need while allowing the collector to...

^^ This. Both for good fit and because it permits removal/replacement of the glass in the future as noted. The filler strips that hold the glass in...

I use Micro Mesh on gular bodies that I've finished with Target Coatings products. While I haven't used 8000cv on them...just EM7000hb and...

If I were buying a new DP these days, the NOVA would get my money, no question. Of the two you mention, I'd probably settle on the Jet. It's larger...

There are some things that the Shopsmith is appreciated for, such as horizontal boring, etc. They are a different animal, but folks who own them tend...

Very sharp, lipped brad-points and a backer board tight to the surface where the drill will exit from the workpiece.

Maybe you can find a roll-up like i used for "carport" type buildings for bringing projects in and out of the booth and have a separate man-door for...

With a 12" inlet and 10h, .I seriously doubt it's a single stage, at least in the sense that we generally envision within the SMC community.

"Because" And I'm right there with you.

Glad you got through that drill.... :D

PEX is not PVC and is not subject to shattering. In fact, one of it's endearing qualities in cold climates is that it's less prone to rupturing...

Bobby, it's not just velocity...there has to actually be air available to move and it takes a lot of air to fill up that 12" main so you can have...

You should have anticipated the cheesy comments...of the Swiss variety in this case. :) :D

Honestly, the big issue here is that the OP has a very large collector and a very large main trunk. The air volume expectations of those two things...

I think MCLS has a bare router motor similar to the PortaMate available. Honestly, I think you're going to just use a dart board to choose and buy at...