It's going to vary with depth of cut as well as width. I tend to take light cuts and seldom have any tearout with straight knives. Extra time to make...
A dado would be fine with a dado set. My outside dado blades have tiny ears on the outside edge of the main blades. These leave a little groove. That...
Ads causing problems? Say it ain't so!! :). For me, noscript and uBlock origin in Firefox are not options, they're required. Ads and the Web are kind...
It's possible to find classic flip phones that work on current generation phone networks. There aren't a lot and I can't attest to their quality but...
Lots of good things to check here, thanks to everyone. I'll report back if I'm able to solve the mystery. It's not urgent because I am able to close...
I'd go along with the 20 amp fuses. It would still be good to know what the motor is actually drawing compared to FLA (full load amps) on the motor's...
Yup, dust collection on that machine did seem like an after thought. If you want to have some "fun" try planing wet pine that creates stringy fibers...
But are they measured in meters/second, kilometers/hour or miles/hour? :). The distance is the distance, the rate is the rate, it's just a matter of...
It seems that aeronautical engineers agree. All dimensions I'm aware of are decimal inches - well, except fasteners. Those have their own conventions...
I did similar, built a little wooden support for the drill press's VFD and drove an eye screw whose eye fits the key and the key is always there. If...
I had a 22-580 for a while. I don't remember it being a sniper, the 540 would leave a good sized snipe on each end but as you said, as long as I held...