Travis Conner
Contributor

I raised it up more Phillip. Definitely a big difference. I hear a smooth cut all the way through where before you could hear it snipe.

I set it up how it said in the directions. Place a straight edge so it's just up against the cutterhead. Still get a bit of snipe.

I put one covering the on off switch and that worked great until a friend moved it and didn't read what it said, so I just leave it tensioned from...

I'll raise it a tad more.

It took like 4 months for that cut to heal too since it was at the tip of my finger it would constantly reopen the cut when I bent it.

True but 50ft isn't much. Lol

I use portable cord sjoow 12 gauge ampacity of 25 amps.

My buddy had one of those kits. Didn't have much luck with it. Then again he's always messing with things

I don't feel like asking a separate question, so I'll add it here. Do you think an engine hoist will lift this thing off the pallet? Gonna have to...

I've never understood why they don't put a removable cover over that slot.

I forgot one time and the blade popped out of the slot next to the on button and cut my finger when I turned it on. It stays tensioned now. No reason...

Yeah it's yellow pine. I'm going to burn it with a torch to give it a neat look, then seal it with some varnish.

I use both depending on what I'm doing, but I use the 3m ear muffs. When I say both i mean one or the other. Like if I'm grinding then I like to use...

I'm pretty sure thats the cost of a new 6" jet