Richard Hutchings
Contributor

If the old chest was solid wood, I'd be picking it up and using the wood. That's how I roll. I've gotten some really nice maple and white oak that...

You'll get a chuckle I'm sure. I was flattening some twisted 2x3s to use for crossmembers in a temporary christmas train table. I have started...

This is such a good thing to do. I applaud you. Having already benefited from a similar give away, I got 2 planes from Steven. I put them both to use...

Of course we want to see the picture of it final setting. This turned out beautifully.

My self imposed limitation would be sheet goods. I'd rather handplane a twisted 2x. I have a lathe and made a bunch things for Christmas presents in...

Sigh, maybe I should build decks. Nooooo, I'm to old for that. Oh well, that's why I decided to work part-time at my job instead of retirement. That...

Let me just add, I don't need to make a living at it. It would be nice to earn a little extra. I'll c9me up with something I'm sure.

I watched 1 and that was enough for me. I just dont like any videos where the person has an accent, only because of my hearing. I don'tunderstand...

I've read and re-read this thread a few times and will probably do it again. I'm still not quite ready for the workshop so I living it through you. I...

The op mentioned it was a spit top. To me, that indicates a a gap between the tops. Let's make sure we know what he is planning exactly.

That doesn't sound like fun. Good luck on that. I'm still recovering from knee surgery. A simple meniscus debreedment. I hope to get back in the shop...

I have no idea about the carcass saw. I need to get out my magnifiers but, I know it sucks at cross cutting. Probably a clue.

I bought the requisite files for sharpening them and will have a go at it one day. I just wonder how good a job they do straight from the factory....

I WAS going to do dovetails for the Dividers...but... Don't the dividers need to be below the frame like you have them? I've never built anything...

I have never used pinch clamps but I would try to have a convex curve on at least one of the boards. Then they clamp in the mid section first and...

Thanks, I may want one.

Bigger screen

I'd argue that you don't need any pressure if the joints are perfect. At least on smaller projects I've gotten good results with rubbed joints. So I...

I've never seen a scraper like that. Home made?

I decided to open the laptop this morning instead of my phone. That board needs to be seen in larger format. I couldn't stop looking and my...

I like your signature ��

Love Gakos

The Number 1F is a straight flat fishtail chisel with a thin and light blade to easily reach difficult areas as the cutting edge is broader than the...

Now I'll have to add, modifying one of my chisels into a fishtail. Thanks for giving me another project Derek.:mad: