View Profile: Earl McLain - Sawmill Creek Woodworking Community

Tab Content: All; Earl McLain; Friends; Photos

Older Activity
Yesterday, 12:32 PM

Earl McLain replied to a thread Delta Slow Speed Grinder Question... in General Woodworking and Power Tools

Derek--picture of the threads on the arbor may help. A rule along side the threads for reference makes the picture even more better. When you say...

see more

4 replies | 253 view(s)
08-10-2022, 1:23 PM

Earl McLain replied to a thread Black Cherry Score in Turner's Forum

Go grab a gallon of cheap white glue--or at least enough to coat the ends of that crotch piece in the front!! earl

see more

14 replies | 531 view(s)
08-08-2022, 1:24 PM

Earl McLain replied to a thread Milwaukee m18 router bushings in General Woodworking and Power Tools

if it's as Jamie Buxton says above, there is one addition that may help. a Centering Cone similar to Bosch part RA1151. This is a tool to get the...

see more

8 replies | 522 view(s)
08-01-2022, 7:22 PM

Earl McLain replied to a thread 14" bandsaw, or can I get by with chainsaw for turning in Turner's Forum

Even with a band saw I usually just cut roughly octagon-ish. Downside to chain saw is that’s a rip cut on a bowl blank to knock off the corners—but...

see more

30 replies | 1994 view(s)
08-01-2022, 2:05 PM

Earl McLain replied to a thread Smocks and Aprons in Turner's Forum

Smock seemed silly to me when i bought a lathe. Didn't take too long to realize i needed to cover my shirt (or take it off and shake it out before...

see more

23 replies | 2542 view(s)
07-30-2022, 8:55 PM

Earl McLain replied to a thread clamping a single box joint in General Woodworking and Power Tools

If you’re making a pair…how about making a rectangle, the cut out opposing corners. Have to allow for he trimming. Would allow for box joint all...

see more

7 replies | 522 view(s)
07-28-2022, 2:10 PM

Earl McLain replied to a thread Interesting new material - hempwood in General Woodworking and Power Tools

I grew up near Nappanee IN and there was a regular supply of “ditch weed”, also known as “Nappanee Nasty”. While there was minimal if any THC, it...

see more

27 replies | 1458 view(s)
07-24-2022, 9:01 AM

Earl McLain replied to a thread Rockler in NJ in General Woodworking and Power Tools

Makes sense to me Jim, thanks!!

see more

24 replies | 2266 view(s)
07-23-2022, 3:11 PM

Earl McLain replied to a thread Rockler in NJ in General Woodworking and Power Tools

Just curious to know if the new NJ and VA stores are company or franchise? I’ve got a franchise that carries a small selection about 45 minutes out....

see more

24 replies | 2266 view(s)

No More Results

Earl McLain
Contributor

Mini Statistics

Recent Visitors

Basic Information

About Earl McLain

Statistics

Total Posts

Albums

General Information

Earl McLain Contributor

Mini Statistics

Recent Visitors

Basic Information

About Earl McLain

Statistics

Total Posts

Albums

General Information

Earl McLain
Contributor