Jared Sankovich
Contributor

The cope of cope and stick joinery, aka scribe if you are British. I'd do it on a shaper, but if you don't have one it doesn't seem any worse...

Imho I much prefer a pallet jack to a mobile base.

Best I can do is a casolin or invicta. The raising mechanisms are generally very simple.

Euro (and south American)machines are within the bounds of owwm. What is the problem, or you just looking for a parts diagram?

While technically likely under the FLA of the motor plate (without seeing it I'm guessing 13-14FLA. ) The likelihood of seeing that on a TS is low....

The 3hp would work. I have one on a 5hp jointer and a 5.5hp shaper. https://www.wolfautomation.com/vfd-3hp-230v-single-phase-12a/

Depending on how they list the vdf. Fuji makes a frenic single phase only line of vfds (up to 3hp) and a 3p/1p line. The 3p/1p are listed as the...

It's either sugar maple (hard maple) or everything else (soft maple). It's nice for paint grade or curly. I picked some silver maple up...

That's only correct on a single phase input rated vfd. If it's a 3p input vfd you need to de-rate.