Jared Sankovich
Contributor

Service manuals for industrial owwm are rare. Usually a parts diagram is about the best you can hope for. What issue are you trying to address?

If you watch at reduced speed It's cleaning up the burn as it passes the knife tje second time on the back of the cutting circle. Knife set to...

I've had the drill router out to rebuild it, and don't recall any interference from the cord.

Watching again it looks like its burning mid cut, then cleans up as the knife passes again.

I'm with you on the "I can't understand how you can cut a tapered tenon on a stacked vertical spindle" Unless like you say the table has vertical...

No drawbar. That class shaper has a dual thread castle nut that pulls it into the taper. Mt5 is common for euro machines that size. The thread size...

You are going to need a stub spindle. Likely a machine shop item.