Jared Sankovich
Contributor

If it's cheap and easy to move in, what is the downside, assuming it's in good condition.

Just curious here but if I read your description you are not using a crosscut sled for plywood panels? All crosscuts are the tso & track?

Might be the bearing, might be the spindle, might be a combination.

Martin USA is the distributor here. I would think their standards are reasonable high to be involved. Granted that occurred more recently than the...

Those bearings run tight. I have one I had to open up to fit one of my shapers. Also your spindle is too short for that setup. 5"-5.25" is pretty...

This worked for my pm180

Your cylinder bore is too small for effective clamping. A 1.0625 bore is only .89 sq inches. Assuming you are running 100 psi that's only 89 pounds...

1.5" is the minimum bore I'd be comfortable with, ideally it would be 2" with a 5/8 rod.

What bore and shaft size are those? That mount needs to be heavier to keep it from deflecting.

100% this. Some off the shelf Freeborn edge heads.

If the ends are not exposed I've cut the back corners off to make the diagonals less that the ceiling height (hidden by a wall or base units)

My 16" newman is a slightly newer design having ball bearings and a 3 knife head. I have no need for a second machine. Skew the fence and slow the...

Leave it 4.5 and add a apron. This is 42x120 at 1.375" thick sapele .

The issue is currents generated in the motor shaft by the vfd that grounds through the bearings. It's a known issue with vfds and the reason for ad...

Only 6 different lengths, for face frames and doors/drawer fronts? I assume you mean for one cabinet not a full kitchen.

I was under the impression (can't remember where I heard it) they were running flat out currently at max capacity/shifts and opening a new...

They are nose mount cylinders. Though there are other configurations.

I like pneumatic cylinders personally. They are cheap, easy to configure, effective as clamps and versatile.

Are all the same radius? and all rebates on the outside of the curve?

It's the toilet paper thing all over again. Shops are buying up everything they can trying to keep some level of supply. The manufacturing didn't...

The ts29 is one of the 5xx series imports. Same machine as a cantek SS512TB. Bearings are double 6008s on top and a 6206 on the bottom. Cantek...

I just checked a order 15" blum slides im waiting on, eta is Dec 29 and they were ordered months ago. Locking devices are showing as April of 2023.

They remove all the material and cut the cope.

A 2.5" integral tenon is usually considered adequate for doors. I don't think 1" is really that much more than a stub tenon. Even dowells would be...

I don't trust cope and stick alone for glass cabinet doors, I certainly wouldn't trust it for passage or exterior doors, short of fully glued...

No, not a rs15. The quill appears identical to the ti-14 and they do share spindles (among other things) To the op, I'd assume you have to pull...

Should be a 6206zz bottom and a 6211z (c3) top

American sycamore. They are about the fastest growing trees I've come across.

Other than storage when not in use I can't think of one. Overall they are cheaper assuming you have more than one machine you want to move. Also...