Frank Pratt
Contributor

I have that same type of attic ladder, but the ladder part is wood. I love it. So easy to operate & very sturdy. I built a box on the underside of...

For surface pipe, I like copper. It looks great & I enjoy working with it. I don't like to use PEX for surface work for the same reason I don't use...

Inside & out.

Unless you have a real good inline dryer, the inside of the pipe would soon be a rusty mess and would tend to puke it out the other end.

Be sure to thoroughly rough up the surface with something like 40 grit sandpaper. The epoxy will need lots of tooth.

I've done 3 wood countertops with under mount sinks. For all 3, I used clear, low viscosity epoxy on the sink cut out edges & underside where the...

I got the wireless remote with mine & keep it clipped to my apron. It's always right where I need it.

What Glenn really needs to do is remove that blocking, take over to the router table & use a round over bit to ease & beautify those hole edges....

Thanks Aaron, I might just give them a call.

I had that very thought as I was posting it. I'm going to do one & laminate it.

I think it would be a good thing if they'd provide a quick reference label that could be applied to a convenient surface. 'Cause ya, who wants to...

Glenn, what sealant are you using? Some are so soft that just walking on a dirty floor can force gunk into the sealant.

I've had issues with Thompson's. If applied thick enough to provide more than a few weeks of protection, then it leaves a sticky, waxy film that does...

Lee Valley used to have a very good selection of screws, including Spax. They still do carry these. ...

Thinning epoxy has serious implications for the strength of the joint. Check with the manufacturer, but even using solvents that they recommend will...

No, it is not an overstatement at all. I've been there. If the cutting board sets in a puddle, or someone unknowingly puts it in a sink of water for...

But "regular white glue" has almost no moisture resistance & the board will begin to fall apart in a hurry.

Definitely a Saab.

Ya, I get that. Sometimes you need to have a voice conversation so both sides understand the meaning. I've had 2 or 3 calls to support with questions...

I built an MDF box for dust collection & bit clearance that drops & locks over my table saw fence. It's a pretty basic fence, but does what I need it...

Besides the quality of the saw, the SawStop manuals are very good as well. Easy to read, easy to understand, and thorough. If the manual can't answer...

I agree with what your trying to accomplish Kev and good on ya. If he goes to prison there's really no chance he'll get rehabilitated.

You should definitely read the manual. Lots of good info in there.

Nobody uses lead for sound attenuation anymore. A couple of layers of 5/8 drywall with Greenglue between works great. Before building something like...

I have a Flexzilla hose & reel hung from the ceiling. Not expensive & it works great. About the only complaint I have is that the put about 5 or 10'...

There are no links or anything to indicate there should be pics that I can see in those posts.

Startup current on induction motors is commonly 10X FLA. If you put a good meter on it, I bet you'd see that it draws a lot more than 90A

That's basically what a couple of restoration guys told me, but they said for some reason it just doesn't work in many cases. Probably has to do with...

HD came to Canada several years before Lowes and for the most part, they have built near a HD, so they're both easy to get to. I tried, but I just...

For getting rid of odors, ozone is very hit & miss, usually miss. That's what the fire & flood restoration guys told me. And if there's enough ozone...