Dave Sabo
Contributor

you should list you location in your profile so people can direct you better. No sense sending you to a supplier in Ft. Lauderdale if you live in...

That's a home brew fence.

Steel and aluminum posts. Composite decking.

Chess - that is a lousy router for use in a table. Besides the drawbacks mentioned , I don’t think it accepts a 1/2” collet. It’s also single...

Don’t think there is any way to not have a non sacrificial fence on a RAS. Freud makes good value priced blades available from lots of places....

Erik - aren’t CC surcharge fees capped at 4% with actual rates being a bit less ? I think we all realize there are costs involved , but 6% seems...

FWIW the TS75 is being phased out , replaced , updated - not sure of the exact nature. But , add that with the already stained supply chain issues...

Another thing y’all might consider is that AMT was an importer more than a manufacture. And their factory was in Taiwan. Think it was...

While I agree the bearings in question are prob. metric sized; Sears was known for sourcing oddball stuff. Could be argued that 4 1/8” is an oddball...

Why do you have to have the panel extend to the floor ? Just massage the detail at the toekick to allow you to stand the cabinet upright (with...

Isn’t it just less stressful to accept things that are known and proven , even if you don’t fully understand them ?

First, the top wouldn’t be scribed. Close enough so the crown has something to attach too. If Paul is scribing all of the top rails on these...

If this is the case, the finished side needs to be integrated with the frame so it looks seamless. A lock miter or even just a 45deg. cut is the the...

Love when an O.P. asks a question never to return. Being that he has a Robland, and to my knowledge, they don't support a pork chop guard - he's...

this is a pretty good bang for the buck ...

The whole system ought to fit in a ridged rifle case.

Maybe try a 28t blade. The Freud in one of mine allows me to push as fast as I can move with good edges in most ply and melamine. I think your...

Roger - so you're saying the B&D is underpowered too? Given my scenario, why would you expect the Festool to do any better ? With a 16tooth...

What exactly are you disagreeing with , and what’s your point. It’s fairly obvious tools wear out at some point. Whether one tool wears out...

Andy - you still haven’t said what you’re cutting, what blade your using , other than it’s a holy cow German blade, or whether you’re making a rip or...

It's not as good in the same way craftsman or husky tools aren't as good as your Wright, Knipex and Snapy ones. They all wrench, or grip or whatever...

The festool saws are not “underpowered”, that’s an urban legend / internet conspiracy. The fact is the have less power than some competitors...

North Hollywood says they have over 50 on hand ...

Aaron are your ceilings finished , or are the floor joists exposed ? If exposed, you can mount the unit so the motor goes between two joists with...

Not following the “fill in “ question. No objections to depth. It’s only an inch and a half. They want the plugs cleanly hidden or they don’t.