Dave Sabo
Contributor

Lot of good suggestions and practices mentioned here but, this is your problem: Get a 20 to 30t dedicated rip blade for 8/4 stock. Thin...

Guess you've never done beaded inset then. Or forgot about the jack miters associated with the frames. There's a reason inset cabinets cost...

um……….no not really. The discussion is over at that point. Assuming it wasn’t - individual vs. monolithic frames don’t change the overlay...

I love the look of inset too. But those are difficult, time consuming , and expensive to execute, especially for the DIYer. They also...

I think it's pointless to make framed cabinets unless you're doing inset doors. I also think partial overlay door look cheap and out of date -...

Couple of things: Hope your endeavor is successful. Sliders are not popular because of your perceived compromises with available miter gauges. ...

What’s your target budget ? What’s your use case ? Hobbyist doesn’t really need Martin quality but an operation running a skid of sheetgoods a...

I prob. woulda added some loctite to the threads before snugging them home.

I would. There’s a school of thought that you need to surface both sides equally (or at least close) in order to keep it from warping in the...