• bobby milam's Avatar
    05-14-2019, 1:00 AM
    bobby milam replied to a thread Cnc Shark HD4 in CNC Machines
    Shapeoko is suppose to be a pretty good entry level machine. I didn’t know that they were priced that low. I’d much rather have one of those over the...
    17 replies | 934 view(s)
  • bobby milam's Avatar
    05-13-2019, 7:29 PM
    bobby milam replied to a thread Cnc Shark HD4 in CNC Machines
    If it is all you can afford then it is usable. You can make some nice things with it but you have to understand that lack of rigidity will make you...
    17 replies | 934 view(s)
  • bobby milam's Avatar
    05-11-2019, 1:29 PM
    bobby milam replied to a thread Cnc Shark HD4 in CNC Machines
    Stinger one is built like a tank compared to a shark. It was welded steel frame and thick heavy gantry. You could stand on it and not hurt it. ...
    17 replies | 934 view(s)
  • bobby milam's Avatar
    05-11-2019, 1:12 PM
    bobby milam replied to a thread Cnc Shark HD4 in CNC Machines
    I typed out a response and it didn't post it so here it is again. I had a Shark. They are by no means a rigid machine which will end up causing you...
    17 replies | 934 view(s)
  • bobby milam's Avatar
    04-22-2019, 11:51 PM
    Gary, do you know what brand oil that is? I have checked a few stores the last couple of days and looked at NAPA online but am not seeing a...
    18 replies | 1964 view(s)
No More Results
About bobby milam

Basic Information

Statistics


Total Posts
Total Posts
234
Posts Per Day
0.10
General Information
Last Activity
Yesterday 7:26 PM
Join Date
01-28-2013