About a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Larry Frank Yesterday, 8:42 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Jimmy Harris Today, 11:46 AMI've got a well head cabinet/enclosure to make which is in a remote location, about a 2 mile hike through the mountains without any trails. I've spent a few hours making measurements, and we will likely make this in sections, and strap them to our backs and assemble it in the field. There is no...
Last Post By: Maurice Mcmurry Today, 7:46 AMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: chris hood Yesterday, 10:16 PMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Jerome Stanek Today, 11:27 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Thanks David - Hillview wasn't on my radar but I'll give them a look. I remember being intrigued by his block plane.
Still obviously on the
I'm located in Piercefield, NY, far from almost everywhere, but this is a scenic area if you want to make a trip and buy this saw. I can ship the fence
Zachary Hoyt Today, 3:42 PM"....I'm sorry, my son, but you're too late in asking....."
Yeah, well, I've read most, if not all, of your posts, and you've seen
He played at our Roots and Blues Festival several times. Ms. got to attend in 2014 and 2017. For some stupid reason I did not go. Here I am getting another
Maurice Mcmurry Today, 3:05 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Koepke Today, 3:49 PM