Had a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Lee Schierer Today, 4:09 PMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: Ronald Blue Today, 8:39 AMHow is the Margin Of Error determined for a survey? I don't care who does the survey or what it's for I'm just curious how the margin is determined and who determines it.
Last Post By: Stan Calow Today, 4:46 PMI'm pondering the economics of a mill vs buying rough lumber at retail/wholesale. In the Bay Area, depending on where you shop hardwoods like Oak and walnut can run up to $15-18bf/ft, or more for the rift/quarter sawn stuff. If one is able to source your own logs, running your own mil and kiln...
Last Post By: Rod Sheridan Yesterday, 8:29 PMI just bought an outdoor Pizza oven. It's an Ooni which can burn wood, charcoal or propane. I plan to start with propane as get accustomed to the pizza oven. Eventually, I want to switch to wood at least occasionally. So, like everyone else on this forum, I always have a lot of cut offs in my...
Last Post By: Pat Germain Today, 3:05 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
"A push poll is an interactive marketing technique, most commonly employed during political campaigning, in which a person or organization
I've made a few chairs now and they're fun! Do it. For this one I would change all of the 1" stick tenons to 3/4". 3/4" tenons are more
Daniel Culotta Today, 4:26 PMI would suggest you pay a few bucks and have a licensed electrician visit your shop, before you damage something.
Lee Schierer Today, 4:09 PMI think you guys are in agreement but the lines get really blurred between surveying (asking a non-biased question) and marketing (asking a leading question).
Edward Weber Today, 3:49 PMI don't even make plans. I just come up with a picture in my head and get to work. I've tried plans in the past. They'll last an hour if they're good.
Jimmy Harris Today, 3:43 PM
Dining room carver chairs - Take 2
Thread Starter: Derek CohenAbout a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Derek Cohen Today, 6:12 AM