Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Joe Calhoon Today, 9:50 AMAbout a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Derek Cohen Today, 11:10 AMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 4:08 PMThere is a person, that has designed very crazy looking squirrel houses. All kinds of fancy, moving parts, and such. He sells the plans to make these squirrel houses in print form, as pdf, and as dxf. He does not sell kits, nor parts. Plans only. Oh his policy page, he writes the following: ...
Last Post By: Edward Weber Today, 6:34 PMAnswer = Tape
Last Post By: Mike Soaper Yesterday, 8:13 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I seem to recall, there are 2 set screws under the swing arm...that can shift the locking pin a little bit, to get it back to square...
I use the wrench slam technique to loosen the nuts on table saws, radial arm saws, bench grinders, miter saws, and such. Use a block of wood to slam
Tom M King Today, 6:41 PMThe fuel filter is some Chinese filter. I couldn't get close enough to read the number. The previous owner may have actually changed the filter. I
Brian Elfert Today, 6:33 PMYou have the answer -- Stephen Roth's reply above, and apparently he's a licensed attorney working in intellectual property and copyright law. Can you
Mike King Today, 6:31 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 6:14 PM