I have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Jim Becker Yesterday, 7:52 PMOne of the things I enjoy about wood working is the potential to learn new skills that enhance my over all enjoyment of the craft. As a Neander, often these new skills don't require an extensive investment in new tools. I've been a hand tool wood worker for >40 years and early on everything...
Last Post By: Maurice Mcmurry Yesterday, 8:33 PMHi, I'm new to the forum. I'm 78 and have been using a Craftsman 10 inch 113.298051 for the last 39 years to build furniture for my house and various projects. I never upgraded until now because the craftsman could do what I needed and I didn't want to spend the money. Last week the fence wouldn't...
Last Post By: Justin Rapp Today, 9:12 AMWednesday, the LOML and I will comence traveling through the State of Washington to Vancouver Island BC. Our travels take us through the Tri Cities, Yakima, Mount Vernon, Vancouver Island, Port Angeles, and down to Portland. Does anybody know of sources on that general path where we might find...
Last Post By: John C Bush Yesterday, 9:58 PMHas any one tried the LV canvas chisel and gouge storage roll? Does meet your need? I think I need a storage solution somewhat safer than the drawer in my tool chest. I have a number of longer chisels stored in a shallow drawer, handles and blades alternating to save space. I have picked up...
Last Post By: Patrick C Daugherty Today, 8:53 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I didn't want to kidnap Kent's thread so I started this one.
Born in the late '40s, I feel blessed to have lived in the 50s, 60s and 70s
Sorry, it is a GA 7. I have not been able to locate any wiring info. The motor is 1ph 3hp 220v
Chris Brooker Today, 11:57 AMI have always approached a log with a specific project in mind rather than just trying to make lumber. Therefore my interest in quarters and rifts. True
Maurice Mcmurry Today, 11:48 AMOh right, Ray Isles. Thanks for the correction.
Mark Leifer Today, 11:29 AMWhat model saw? You often can find wiring diagrams that way.
John
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Yesterday, 5:52 PM