About a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: Jim Ritter Today, 12:59 PMLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Brian Elfert Yesterday, 3:21 PMAfter a lot of searching, the Hammer A3-31/41 (or possibly the SCM Minimax) with a helical head, is my next piece of shop equipment. Where would I look for either machine used? I've tried the usual suspects, FB Marketplace (seems to be limited to local only), Craigslist (seems to be losing...
Last Post By: Jonathan Biccum Today, 1:11 PMOne of those sitting at the computer in the morning with a cup of coffee itching to buy a new tool ... So I come across this Veritas Scraper Burnisher for Turners and looked at a few videos reviews of it and thought why not. After reading a few reviews posted on this forum I later realized it was...
Last Post By: Michael Burnside Today, 1:48 PMSo our old microwave a GE bit the dust, was perhaps 20 years old. Purchased a new one and instructions said needs to be 13 inch deep cupboard at the most, and duh the door now hits. Never did on the old as it was a different door design. GE wants $75, Home Depot $130 eBay $75 but with free...
Last Post By: Bill George Today, 2:03 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Yup I have the old U shaped bracket I used in place of the new. Wall behind will have a piece of 3/4 inch plywood attached to studs and toggle bolts as
Bill George Today, 2:03 PMI could certainly see that for areas where lawns grow 1"/week, that is pulling in a lot of of carbon. Also, at least out here in California, where
Mark Wedel Today, 2:01 PMjoe, the flat setup with the multi use is. brilliant. i’ll try that. i assumed the piece was vertical up against the fence…
David Zaret Today, 1:55 PMYes, I like the magnetic feature as it makes it a snap to remove a plug when the hole needs to be used. They came from a fellow trading as Bad Yorkie
Jim Becker Today, 1:48 PMMy sentiments match Jim’s. I’m not a packrat and so if I have something I’m not using, it goes bye bye. Over the years I’ve learned my workflow and what
Michael Burnside Today, 1:48 PM
California bans the SALE of gas lawn mowers and leaf blowers after 2024
Thread Starter: Bill DufourSaw a sign at hoe despot and looked it up. California has banned the sale of gas lawnmowers and leaf blowers after 2024. If yours is getting tired better buy a new one in a few months. I assume they will be gone from stores by Fall. It will probably take ten to twenty years until this ban goes...
Last Post By: Mark Wedel Today, 2:01 PM