• Recent Polls

    What are your thoughts? (Votes: 6)

    1. Been doing it like (or equivalent) this for years. (Votes: 4)

    2. Wow! Never thought of that. (Votes: 0)

    3. Been doing it with mirrors. (Votes: 2)

    4. Ain't got a boat, truck, care… (Votes: 0)

  • Recent Forum Posts

    Roger Feeley

    Home Depot cheerful refunds

    I got a 10’ piece of 1” black iron pipe and had hm cut it into 2 pieces. The bar code was too badly damaged to read so I snapped the shelf tag. The employee

    Roger Feeley Today, 6:32 PM Go to last post
    Warren Lake

    Card "scraper" or something else?

    any examples of an excellent finish from a card scraper. Ive seen past hand work from people with planes and its not consistent. Then on purpose

    Warren Lake Today, 5:49 PM Go to last post
    Jimmy Harris

    Card "scraper" or something else?

    Most scrapers make use of a burr, but not all.

    Either way, scraping, planing, burr, no burr... you're performing the same action. It's

    Jimmy Harris Today, 5:33 PM Go to last post
    Warren Lake

    Sumpy 2

    Found one new file and five old ones question answered the new file cuts great compared. At 70 to 100 strokes per tooth it goes down hill. Didnt find

    Warren Lake Today, 5:01 PM Go to last post
    andy bessette

    Wooden skiff; How to seal leak around a centerboard?

    This is an area that typically gives trouble. An area of high stress, and one inherently challenging to design and build strong enough for the accidental

    andy bessette Today, 4:41 PM Go to last post
  • Recent Blog Posts