Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 5:04 PMSaw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Nicholas Lawrence Today, 8:16 AMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Bill Dufour Today, 11:13 AMPlease, this is not a question asking how to best sharpen hand tools, it is a simple question to ceramic stone users. How hard are they to maintain? My diamond plates are years old and do not cut as aggressively as in the past. I have a selection of water stones of known and unknown grit for...
Last Post By: John C Cox Yesterday, 4:35 PMWifey said I have to wait until tomorrow before opening the Shaper Origin but I tricked her into allowing me to open the workstation early :) Got the workstation mounted on my Husky toolbox with a raising table so I can do some box joints on 48" long stock, for an upcoming project. I've also...
Last Post By: Michael Burnside Yesterday, 9:16 PMI believe the OP replaced a three phase motor and has never run his new single phase motor from any other outlet. It is possible the motor has something
Bill Dufour Today, 11:13 AMI wondered myself. I got that 45 amps from some website. I also saw around 30 amps which I believe. My 5hp single phase compressor is on a 30 amp/240
Bill Dufour Today, 11:10 AMTwo comments.
First, I think I would just build boxes (in whatever dimension you choose) and stack them, fasten them together and fasten
I'm curious where you're getting your Full Load Amp data from. Baldor 7.5HP single phase 240V motor shows 33Amps full load and the Leeson shows around
Tony Shea Today, 10:55 AMThat definitely looks like a Bosch 1617 in Craftsman paint. That's a good router, and as noted, probably just needs a new power switch. You should be
Jimmy Harris Today, 10:54 AM
Left lane
Thread Starter: Ole AndersonLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Mike Wilkins Yesterday, 11:09 PM