Saw a sign at hoe despot and looked it up. California has banned the sale of gas lawnmowers and leaf blowers after 2024. If yours is getting tired better buy a new one in a few months. I assume they will be gone from stores by Fall. It will probably take ten to twenty years until this ban goes...
Last Post By: Tom M King Today, 9:25 AMLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Larry Edgerton Today, 9:59 AMAbout a year ago I was reading and found that Vietnam veterans qualified for VA medical benefits. About the same time, I was talking with a neighbor who came over to ask me about hearing aids. I have bimodal hearing; I have a cochlear implant (CI) on one ear and a hearing aid (Ha)on the other ear...
Last Post By: Mike Henderson Yesterday, 2:00 PMI have a baldor 7.5HP BALDOR 3450RPM 213T TEFC 1PH MOTOR L3709Ton my table saw. What type of grease should I look for to put grease in the grease or zirk fitting?
Last Post By: Karl Card Yesterday, 10:07 PMHi all, I have a Laguna Cflux-3 that was giving me some intermittent issues turning the unit on and would take a few hits of the switch or remote control 'on' to get it to start up. Today, the motor won't start at all. I do get a 'beep' coming from the circuit board when turning it on and the...
Last Post By: Justin Rapp Today, 9:03 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Sometimes it helps to cut it on its side instead of on the top or bottom.
I know a good serrated blade, like the one on my Spyderco kitchen
HA! when I was young I lost my license seven times in three states. I was definitely a left laner, but maybe not in the way you alluded to.
Larry Edgerton Today, 9:59 AMI was asked to help my granddaughter with her math and I was surprised to see that the way they are teaching is the same methods that I came up with 40
Larry Edgerton Today, 9:57 AMI would like a suggestion for a finish for a set of dining room chairs. I would like a satin wipe-on or brush on finish that is easy to apply. I just
Howard Pollack Today, 9:49 AMIt's far more common that a "chuck" is screwed onto the headstock threads rather than mounted via a morse taper.
I feel there is something
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Koepke Yesterday, 5:10 PM