Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 5:04 PMSaw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Nicholas Lawrence Today, 8:16 AMPlease, this is not a question asking how to best sharpen hand tools, it is a simple question to ceramic stone users. How hard are they to maintain? My diamond plates are years old and do not cut as aggressively as in the past. I have a selection of water stones of known and unknown grit for...
Last Post By: John C Cox Yesterday, 4:35 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Michael Schuch Yesterday, 11:31 PMLooking to upgrade from my old 6" Jet JJ-6cs jointer (which I put a helical head on). I just have a hobby shop for personal use but would like to get an 8" jointer since I find the 6" too small. I've for the most part settled on Grizzly for their affordability and overall good reviews. G0490ZX:...
Last Post By: Warren Lake Yesterday, 10:23 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I just went and took apart a Bosch 1617dvs. See the pic. below, the OPs router is definitely a Bosch.
I built a little outdoor breakfast table last weekend. Tried the Atkins you sent me. It needs to be sharpened and tuned, particularly a touch more set
Nicholas Lawrence Today, 8:39 AMI'm 99% sure that's a Bosch router in disguise. If so, the Bosch routers are notorious for getting sawdust inside the switch when used in a table. Try
John Lanciani Today, 8:31 AMHe is referring to the comic scenes I think.
People (mostly people who talk about books they have never read and plays they have never seen)
so much to do.. all new lighting, almost all Ballasts are out. Really looking forward to this, and improved health soon.
Bill George Today, 8:08 AM
Left lane
Thread Starter: Ole AndersonLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Mike Wilkins Yesterday, 11:09 PM