My friend in So. Dk. was given a fair amount of Osage Orange. He hauled home and called me to tell me how heavy it was. He said it had been in a barn for several years and was thrilled to have. The next day his back was hurting severely. He lives in a small town that has pretty good medical care....
Last Post By: Maurice Mcmurry Today, 8:19 AMAnswer = Tape
Last Post By: Larry Edgerton Yesterday, 10:48 AMHi folks, I'm looking for advice on whether to ignore/repair/euthanize a misaligned Dewalt 735. A couple of years ago, I bought a used Dewalt 735 from a guy who had already installed a byrd cutterhead on it. I've recently realized that it is out of parallel by ~0.013". Picture attached...
Last Post By: Sam Shankar Today, 8:47 AMWhile reviewing different approaches in preparing card scrapers I found the method used by Rob Cosman to be the most involved. Basically he recommends flattening and polishing the 3 surfaces of each side, eventually using a 16000 grit Shapton stone. He also employs the Charlesworth ruler trick to...
Last Post By: Derek Cohen Yesterday, 11:30 PMi have a adapter for a chuck on a morse taper and it works great,,my only problem is then i put it in the headstock to use it come out after you turn the machine on the morse taper comes out,,,i know you can make a drawbar for it but my problem is,, its flat with no threads,,it has a small hole but...
Last Post By: jeff oldham Yesterday, 9:42 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
The Son of a D Day survivor gave a talk and showed his Dads slides & memorabilia at our Historical Society yesterday. I wanted to attend but had to
Maurice Mcmurry Today, 9:01 AMI’m so pleased that this thread has been helpful. It’s amazing how a bit of peer advice can be 10 times better than manufacturer instructions and save
Sam Shankar Today, 8:47 AMThe Mandocello is a beauty. A Mandocello can be a formidable beast with a wicked sound. Attending a Mike Marshall concert is on my to do list. Making
Maurice Mcmurry Today, 8:19 AMI experienced tool bouncing yesterday when I was roughing out a few bowls. I think the issue is the cutting force on the tool changing going from end
Jim Barkelew Today, 7:50 AMHi all, I recently bought a stanley 246 miter box. Fantastic piece of kit.
I have to issues I would like help with.
1. The rear roller slightly
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Koepke Yesterday, 8:46 PM