My router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: Dan Rude Today, 4:19 AMHow is the Margin Of Error determined for a survey? I don't care who does the survey or what it's for I'm just curious how the margin is determined and who determines it.
Last Post By: Jim Koepke Today, 2:00 AMBeen watching Matteo for years and now many top players are recognizing him. I think hes 24 now. Video is not great and sound not great but I can hear whats going on. Very nice of Joe to bring him up and others that are spending time with him. Hes innovative. Very unique finger picking style....
Last Post By: Maurice Mcmurry Yesterday, 8:44 PMI'm pondering the economics of a mill vs buying rough lumber at retail/wholesale. In the Bay Area, depending on where you shop hardwoods like Oak and walnut can run up to $15-18bf/ft, or more for the rift/quarter sawn stuff. If one is able to source your own logs, running your own mil and kiln...
Last Post By: Maurice Mcmurry Yesterday, 7:06 PMI'm down to 2 routers and need a couple more. I have read the 690's aren't what they used to be. Suggestions?
Last Post By: John TenEyck Today, 10:26 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Two of these will cover the whole point and still drop some water back in the lake. One on a fixed post on the right hand side a couple of hundred feet
Tom M King Today, 12:18 PMThanks very much, Glenn. Yes, I'm pretty sure it was a design by Tim Rousseau, whose work is always a delight to me. I think the base of the dining table
John TenEyck Today, 12:14 PMNo laws, but the power company that operates the lake used to have a 2" pipe size limit for any individual's intake. Virginia Beach started pulling
Tom M King Today, 12:13 PMTo answer that question, I plan to use one of these fish safe self-cleaning intake strainers. It requires 42 gpm to operate. This will be the most expensive
Tom M King Today, 12:09 PMHAHA... only four? FOUR???
I have ten, count 'em, TEN pairs of "readers".. +1.00 to +3.25 in *ahem* 0.25 steps, about $3 per pair
Help with low motor power on table saw
Thread Starter: Karl CardHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Tony Shea Yesterday, 5:28 PM