• Rich Engelhardt

    There is no available content written by Rich Engelhardt
  • Recent Polls

  • Recent Forum Posts

    Mark Hennebury

    Tenoner rebuild

    Hi Joe,

    The saw travels together with the shaper head. At this point i am much in the dark as to how it works for setup and adjustments.

    Mark Hennebury Today, 10:37 AM Go to last post
    Jim Dwight

    Bondo

    I recently used bondo on my front door. It used to have a mortise lock I did not want. So I removed it, cut a 5x4x1 inch piece of oak to fill the hole,

    Jim Dwight Today, 10:36 AM Go to last post
    Frank Pratt

    Material advice/ideas needed

    That plate looks to be identical to the Infinity insert, which I have. The replaceable inserts sound like they're the same too; the cheapest MDF in existence.

    Frank Pratt Today, 10:34 AM Go to last post
    Jim Dwight

    Considering a router lift

    I have a home made router lift in my router table that is based upon plans from an old American Woodworker article. The lift bolts to the back of the

    Jim Dwight Today, 10:32 AM Go to last post
    brent stanley

    Small Shaper tooling

    Like Darcey says, 5k ought to get you into very good territory for a used shaper! They are very simple machines and easy to assess on site when you go

    brent stanley Today, 10:29 AM Go to last post
  • Recent Blog Posts