• Recent Articles

  • Recent Article Comments Widget

  • Hottest Threads

    Michael Arruda

    Home Depot return policy change without notification

    Thread Starter: Michael Arruda

    Hello all, I had some small items left over from various things I've done around the house recently and decided to gather them up to take back to Home Depot. These items were purchased at various times over the past couple weeks and I of course misplaced my receipts. Meaning they got washed,...

    Last Post By: Edwin Santos Today, 11:34 AM Go to last post
    John McGovern

    Table Saw Questions

    Thread Starter: John McGovern

    Hi All, I've been lurking in the weeds for some time and have found this venue to be the most knowledgeable, helpful, and courteous forum on the block. And, I know this question has been asked and answered so many times, but I hope you all have the patience for one more dip to the well to answer...

    Last Post By: David Buchhauser Today, 6:52 AM Go to last post
    Paul F Franklin

    New Lee Valley Web Site

    Thread Starter: Paul F Franklin

    Seems the roll out of the new site is not going completely smoothly. Have been trying to place an order all morning and the site just spins when I try to checkout. Tried a few different browsers too. Guess I may have to call :eek: New site design seems nice and clean though but it will take...

    Last Post By: Jim Koepke Today, 10:30 AM Go to last post
    Steve Rozmiarek

    Good quality mobility bases?

    Thread Starter: Steve Rozmiarek

    Anyone have recommendations on decent quality and reasonably priced mobility bases for table saws? I haven't paid any attention to the market in years, googled yesterday and was a little shocked at the prices I saw. Last I remember, they were half of what I'm seeing now. Bases for would cost...

    Last Post By: Jim Becker Today, 10:43 AM Go to last post
    Dennis McDonaugh

    Auto Darkening Welding Helmet

    Thread Starter: Dennis McDonaugh

    I know you guys have lots of experience with other tools -- I'm looking for a good welding helmet. I know some of the cheap ones react too slowly or have other issues. Anyone have a recommendation for a good helmet in the <$200 range?

    Last Post By: John K Jordan Today, 9:00 AM Go to last post
    Matt McGill

    recommendation for band saw purchase

    Thread Starter: Matt McGill

    I'm looking to get a band saw for under $2000. I'm a total woodworking rookie ... it's been a hobby for about 5 years. About every 6 months I'll look into band saws and then talk myself out of getting one. Then I'll do a project where I wish I had one... Every time I go "low end" on a (power)...

    Last Post By: David Micalizzi Today, 10:35 AM Go to last post
  • Mike Berrevoets

    There is no available content written by Mike Berrevoets